Details: ACCENTRA (formerly Yale) 6170ED Electrified Surface Vertical Rod Exit Device

• Activation: Alarm is armed by turning key clockwise. Low audible chirp indicates alarm has been activated. Alarm will sound when the exit device pushpad is depressed. Factory preset for standard alarm mode which automatically resets after 5 minutes.
• Continuous Alarm Mode: Alarm sounds continuous when the exit device pushpad is depressed. Alarm must be manually reset by keyswitch. (This feature is selected by a switch on the circuit board.)
• Low Battery Warning: Audible chirp.
• Nuisance Alarm: Factory preset for instant alarm. Selectable feature for alarm to sound when pushpad is depressed for more than 2 seconds. (This feature is selected by a switch on the circuit board.)
• Arming Delay/Authorized Egress: 10-second delay (after arming) permitting egress (by turning key clockwise).
• Alarm Shunt: Ingress shunt alarm input for devices with latchbolt position (S) monitor. NOTE: 'S' included with SVR devices.
• Power Requirements: One 9-Volt Battery (included).
• Loudness: 90db @ 10 feet.
• Arm/Disarm: Uses one 1-1/8" straight cam mortise cylinder. Clockwise turn arms the alarm, counter clockwise turn disarms or silences the alarm.
• Device Status: A Red LED indicator will illuminate every 30 seconds when the alarm is armed.
• Tamper Resistant: Built-in safety monitor sounds alarm when tampering occurs.
• Warning: 'A' supplied with "EMERGENCY EXIT - ALARM WILL SOUND" decal
• Standard 36" device fits doors 35"-36" Device cannot be cut less than 35".
• Option -48 fits doors 41"-48". Devices cannot be cut less than 41".

• Provides indication of the pushpad being depressed. Used as a Request to Exit switch to shunt alarm systems, release electromagnetic locks or monitor egress.
• Electrical Specifications: 4 Amps @ 250VAC contacts
• Listings: UL/cUL listed for panic and fire exit hardware.
• Note: Not available with the "A" Alarm kit option.

• Provides indication of the trim being operated from the outside. Used as a Request to Enter signal switch to shunt alarms, also used to monitor entry.
• Electrical Specifications: SPDT contacts rated 5 amp @ 28VDC
• Listings: UL/cUL listed for panic and fire exit hardware.

• Provides indication on the position of the latchbolt. Used with security systems to monitor the latchbolt, also used to activate automatic door operators upon latch retractions.
• Electrical Specifications: SPDT contacts rated 5 amp @ 28VDC
• Listings: UL/cUL listed for panic and fire exit hardware.

Electrical Specifications

• Solenoid Assembly
• Continuous duty
• 9 amp inrush
• Requires a 4-wire minimum pivot or hinge to transfer power from frame to door.
• Requires the 782 controller for operation (USING ANY OTHER POWER SUPPLY VOIDS THE WARRANTY OF THE DEVICE.)

Listings

• UL/cUL listed for panic and fire exit hardware. Fire-rated devices must be wired into an automatic fire alarm system.

• Public Buildings & Facilities
• Commercial & Industrial Buildings
• Government & Military Facilities
• Retail & Strip Malls
• Multifamily & Mixed-Use